Publicidad
Idiomas disponibles
Idiomas disponibles
14. TROUBLESHOOTING
FAULT
TIBODA DOES NOT TURN ON
TOO MUCH VIBRATION IN USE
THE BATTERY SWITCH AND STATUS INDICATOR
LIGHT UP BUT TIBODA DOES NOT MOVE
THE DISPLAY IS LOCKED AND AN
ERROR IS DISPLAYING
14.1 Error codes
The error codes are listed in the following table
CODE
0
1
2
3
4
5
6
7
8
9
WARNING!
The display stops working if a fault occurs. Contact a service centre to resolve the
problem
CHECK THAT THE BATTERY IS PROPERLY
INSTALLED AND TURN THE KEY CLOCKWISE.
IF THE BATTERY IS CHARGED AND PROPERLY
INSTALLED, CONTACT YOUR SERVICE CENTRE
CHECK THAT THE CLAMPS, PLATES AND STRUT
ARE PROPERLY FASTENED TO THE WHEELCHAIR
CHECK THAT THE PLUG/CABLE CONNECTING
THE MOTOR TO THE CONTROLLER, ON THE
FORK, IS PROPERLY CONNECTED; IF IT IS
NOT, CONTACT YOUR SERVICE CENTRE
SHUT THE PRODUCT OFF AND ON AGAIN. IF THE
ERROR PERSISTS, CONTACT YOUR SERVICE CENTRE
When the TIBODA's electrical system has problems,
the display automatically reports the error code at the
bottom right.
DEFINITION
NO PROBLEM
BRAKE LEVER FAULT
ACCELERATOR FAULT
CONTROLLER FAULT
UNDER VOLTAGE
MOSFET FAULT
OVER TEMPERATURE
OVER CURRENT
OVER VOLTAGE
CONTROLLER COMMUNICATIONS FAULT
SOLUTION
CHECK THE BATTERY CHARGE -
RECHARGE THE BATTERY
31
Publicidad
