CADstar CS.Neo2 Manual De Instrucciones página 10

3.3 Power supply unit
Technical data of the power supply unit
Use only the supplied power supply and power cord. The power supply unit may only be connected to a socket
with a protective contact.
3.4 USB cables
If possible, use the supplied cable. If you use your own USB cable, pay attention to the following properties. Full 5Gbit USB C cable with
shielding maximum 1.4m. For extensions beyond 1.4m, an active USB extension must be used.
For scanners with 2 USB cables, make sure that the full bandwidth is available for each of the two USB cables.
(Often USB connectors share the speed)
3.5 Accessories
Each scanner is delivered with the standard accessories. Further accessories can be purchased for certain functions.
NOTE! Only use original accessories.
Otherwise, warranty provisions and product liability risks could be affected.
Take care of the calibration plate so that the surface is not damaged.
4. Function and installation
This optical 3D scanner is designed for the dental fi eld to measure and digitize jaw models in three dimensions. Based on the principle of
"fringe light scanning", a fringe light pattern is projected by a projector onto an object to be measured. The distortion of the light pattern
caused by the structure of the model is registered by four high-resolution cameras installed in the scanner unit, processed and thus digi-
tized into a virtual and three-dimensional model.
4.1 Installing the scanner
After setting up the scanner, connect it with one or two USB cables, then connect the 24V supply to the external power grid and plug in the
power supply.
If the USB cables are too short, they can be extended with special active extensions. Contact CADstar for appropriate products. Important
note for devices with two USB connections, it must be ensured that the two USB ports on the PC do not belong to the same USB controller
/ HUB, since the scanner requires the full bandwidth of 2x 5GBit/s. This means that a total of 10 GBit/s must be available.
Property Value
Manufacturer MEAN WELL
Type GST90A 24 – P1M
Input 90 ~ 264VAC
127 ~ 370VDC
47 ~ 63Hz
Power 90W
Output 24 V, 3.75 A
9 / EN