Publicidad
Idiomas disponibles
Idiomas disponibles
4.2 Installing the computer
The scanner software requires at least Windows 10 or newer. Make sure that all drivers are up to date (graphics card, USB host, mother-
board, etc...). Observe the recommended minimum PC workstation requirements to ensure smooth scanner operation.
4.3 Installing the software
The scan software is already pre-installed on the workstations supplied. If this is not the case, the software can be obtained from your
dealer or installed remotely by our customer service. Contact CADstar Technology customer service to do so. See the chapter "Customer
service."
Note that an internet connection must be available to license the software. This must be done for each new installation.
5. Working process
After you have started the software, you must execute the scanner calibration under the Options menu. To do this, place the calibration
plate in the scanner and start the calibration.
Homepage scan software
After successful calibration, you can create a new case. Following fi elds are mandatory and need to be selected or fi lled out:
•
Patient
•
Doctor
•
Model type
•
Scan mode type
Once you are in the scan menu, you can scan a model that is in the scanner.
EN / 10
Refer to the user manual of the PC.
Administrator rights are required for the installation.
Our support works with "TeamViewer". Please download this software (www.teamviewer.com). After installation,
please have your ID and password ready so that our support can connect to your computer.
Options > Scanner calibration OR Menu
For further details, please refer to the software operation manual.
Options > Scanner calibration
Publicidad
