Publicidad
Idiomas disponibles
Idiomas disponibles
3. With the ignition key in the on position (A), push
down on the rearward pedal. The engine must stop
when you push down on the rearward pedal.
A
4. Start the product and engage the cutting deck again.
5. Turn the ignition switch to the ROS on position (B).
6. With the ignition key in the ROS on position, push
down on the rearward pedal. The engine must not
stop when you push down on the rearward pedal.
Operation conditions
These conditions are necessary to start the engine:
•
The parking brake is applied.
•
The drive of the blades is disengaged.
•
The forward pedal and the rearward pedal are in
their neutral position.
The engine must stop in these situations:
•
The parking brake is not applied and the operator
lifts from the seat.
•
The cutting deck is engaged and the operator lifts
from the seat.
•
The cutting deck is engaged and the rearward pedal
is pushed down but the ROS is disengaged.
The drive of the blades must stop in these situations:
•
The parking brake is applied and the operator lifts
from the seat.
•
The blade engagement control is moved to the
disengaged position (applicable for the TS 112
model only).
•
The PTO button is pushed in (applicable for the TS
114 model only).
Try to start the engine without one of the conditions.
Change the conditions and try again. Do this check
daily.
To do a check of the forward pedal and rearward pedal
1. Start the product. Refer to
page 16 .
2. Make sure that the forward pedal and rearward
pedal are not blocked and can be operated freely.
3. Slowly push the forward pedal to move forward.
10
B
To start the engine on
4. Release the forward pedal to brake. Make sure
that the brake engages when the forward pedal is
released.
Note:
The product has an automatic brake that
engages when you release the pedals.
5. Do the same procedure for the rearward pedal.
6. Make sure that the product does not move when the
pedals are in their neutral position.
Parking brake
WARNING:
not work, the product can start to move
and cause injury or damage. Make sure that
the parking brake is regularly examined and
adjusted.
To do a check of the parking brake on page
Refer to
22 .
Muffler
The muffler keeps the noise levels to a minimum and
sends the exhaust fumes away from the operator.
Do not use the product if the muffler is missing or
defective. A defective muffler increases the noise level
and the risk of fire.
WARNING:
hot during and after use and when the
engine operates at idle speed. Be careful
near flammable materials and/or fumes to
prevent fire.
To do a check of the muffler
•
Examine the muffler regularly to make sure that it is
attached correctly and not damaged.
Protective covers
Missing or damaged protective covers increase the
risk of injury on moving parts and hot surfaces. Do
a check of the protective covers before you operate
the product. Make sure that the protective covers are
correctly attached and do not have cracks or other
damages. Replace damaged covers.
To cut grass on slopes
WARNING:
instructions that follow before you use the
product.
•
To cut grass on slopes increases the risk that you
can not control the product and that it overturns. This
can cause injury or death. It is necessary to cut the
grass carefully on all slopes. If you cannot reverse
up a slope or if you do not feel safe, do not cut it.
If the parking brake does
The muffler becomes very
Read the warning
1825 - 003 - 08.02.2023
Publicidad
