Publicidad
Idiomas disponibles
Idiomas disponibles
3. Connect one end of the black battery cable to the
NEGATIVE (-) battery terminal (C) on the charged
battery.
4. Connect the other end of the black battery cable to
a CHASSIS GROUND (D), away from the fuel tank
and the battery.
To remove the jumper cables
Note:
Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
To replace the battery
WARNING:
burn injuries. Do not use metal wristbands
or other metal accessories. Metal items that
touch the battery terminals can cause burn
injuries, electrical shock, and short circuit of
the battery.
1. Stop the product.
2. Fold the seat forward.
3. Remove the terminal cover on the black battery
cable.
4. Remove the screw, the nut, and the black battery
cable from the negative (-) terminal on the battery.
WARNING:
and burn injuries. The black battery
cable must be disconnected before you
disconnect the red battery cable.
5. Remove the terminal cover on the red battery cable.
6. Remove the screw, the nut, and the red battery
cable from the positive (+) terminal on the battery.
7. Carefully remove the battery from the product.
8. Put a new battery in position.
1825 - 003 - 08.02.2023
Risk of electrical shock and
Risk of electrical shock
9. Attach the red battery cable to the positive (+)
terminal on the battery and install the nut and the
screw.
WARNING:
and burn injuries. The red battery cable
must be connected to the positive (+)
terminal before you connect the black
battery cable to the negative (-) terminal.
10. Attach the black cable to the negative (-) terminal on
the battery and install the nut and the screw.
11. Install the terminal covers.
Tire pressure
Make sure to have the correct tire pressure on all 4 tires.
Technical data on page 38 .
Refer to
Cutting deck
To remove and install the cutting deck
1. Disengage the cutting deck and stop the engine.
2. Put the cutting deck in the lowest position.
3. Remove the 2 screws and the left belt cover.
4. Remove the 2 screws and the right belt cover.
5. Move the drive belt off the left blade pulley to
decrease the tension of the drive belt.
6. Remove the drive belt from the engine pulley.
7. Do the steps that follow to disconnect the front link.
Risk of electrical shock
25
Publicidad
