Hella Gutmann CSC-Kit Radar III Manual De Instrucciones página 34

5. | Working with the Radar Kit III
WARNING
Sharp object
Risk of injury or piercing
Always use the handle to attach the wheel alignment module to the rim flange or tire.
CAUTION!
Scratching of surfaces
Damage to wheel rims
Always attach the spacer-set to the rim flange or tire.
2. Loosen the set screw of the shaft with the cross connector.
Now you can adjust the height of the shaft with the cross connector.
3. Align the shaft with the cross connector (15) to the wheel center (1).
4. Align the scales of the wheel alignment module in right angle.
NOTICE
Pay attention that the level bubbles of both wheel clamp modules are centered.
The distance between the base support and the center of the wheel can be measured with a tape measure
(not included in the delivery contents) only if the wheel alignment module is attached horizontally and cen-
tred to the wheel center.
5. Align the laser module to the even ground by turning it.
34
Hella Gutmann
CSC-Kit Radar III