Selco WF 109 Instrucciones De Uso página 42

3.15 Stick out calibration
Allows the calibration of the system for special operating condi-
tions.
Enter set-up by pressing the encoder button for at least 2 sec-
onds.
Select the required parameter (36) by rotating the encoder until
it is displayed within the central quadrant (5).
Activate the regulation of the selected parameter by pressing the
encoder button.
Carry out a reference weld.
Save and exit the current screen by pressing button (4)
3.16 Alarms screen
Allows the intervention of an alarm to be indicated and provides
the most important indications for the solution of any problem
encountered.
1 Alarm icon
2 Alarm code
3 Alarm type
Alarm codes
E00 General alarm
E01 Temperature alarm
E04 Communication alarm (PSR)
E05 Current too high alarm
E07 Wire feed motor supply alarm
E08 Blocked motor alarm
42
E10 Power module alarm
E11 System configuration alarm
E12 Communication alarm (WF - PSR)
E13 Communication alarm (RC 300 - PSR)
E14 Program not valid alarm
E16 Communication alarm (RI)
E20 Memory fault alarm (PSR)
E21 Data loss alarm (PSR)
.
E22 LCD display alarm
E23 Memory fault alarm (RC)
E24 Data loss alarm (RC)
E25 Memory fault alarm (WF)
E26 Data loss alarm (WF)
E40 System power supply alarm
E41 Overvoltage alarm
E42 Undervoltage alarm
E43 Coolant shortage alarm
E44 Gas shortage alarm
E49 Emergency switch alarm
E50 Wire stuck alarm
E51 Unsupported settings alarm
E52 Anti-collision alarm