Publicidad
Idiomas disponibles
Idiomas disponibles
C
Automatic fault warnings and what to do
Trouble code
F5
Insufficient water
F3
Continuous water input
F2
Inability to discharge water
F8
Heater error
F1
Overflow
FE
Faulty electronic card
F7
Overheating
F6
Faulty heater sensor
The installation and repairing procedures should always carried out by the Authorised Service
Agent in order to avoid possible risks. The manufacturer shall not be held liable for damages
that may arise from procedures carried out by unauthorised persons. Repairs may be carried
out by technicians only. If a component has to be replaced, ensure that only original spare
parts are used.
Improper repairs or use of non-original spare parts may cause considerable damage and put
the user at considerable risk.
Contact information for your customer service can be found on the back of this document.
Function-relevant genuine spare parts according to the corresponding Ecodesign order can
be obtained from Customer Service for a period of at least 10 years from the date on which
your appliance was placed on the market within the European Economic Area.
Useful information
Possible fault
38
What to do
Make sure the water inlet tap is open and
water is flowing
Separate the inlet hose from the tap and
clean the filter of the hose.
Contact for service if the error continues.
Close the tap and contact for service.
Water discharge hose and filters may be
clogged.
Cancel the program.
If the error continues, contact for service.
Contact for service.
Unplug the machine and close the tap.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
EN
Publicidad
