Dexter 20VMPS2-85.1 Manual Del Usuario página 121

WARNING: When not in use, place circular saw on a stable surface, shoe side down, where it will not cause a tripping or falling hazard.
Some tools with large battery packs will stand upright on the battery pack but may be easily knocked over.
WARNING: Some dust particles created by power sawing, contain chemicals known to cause cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
•
Lead from lead-based paints.
•
Crystalline silica from bricks and cement and other masonry products.
•
Arsenic and chromium from chemically treated lumber.
Your risk from these exposures varies, depending upon how often you do this type of work. To reduce your exposure to these chemicals:
•
Work in a well-ventilated area.
•
Work with approved safety equipment, such as those dust masks that are specially designed to filter microscopic particles.
LASER BEAM
DO NOT STARE INTO BEAM
Laser Class 2
λ: 650 nm; P≤1mW
EN 60825-1:2014
SAFETY INSTRUCTIONS FOR LASER
The laser guide used in the tool is Class II with maximum output 1mW and wavelength 650nm.The laser guide do not normally present an optical
hazard, although staring at the beam may cause flash blindness.
CAUTION! The use of optical instruments with laser product will increase eye hazard.
• Do not stare your eyes to the laser beam.
• The laser shall be used and maintained in accordance with the manufacture's instruction.
• Never aim the beam at any person or an object other than the work piece.
• Always ensure the laser beam is aimed at a sturdy work piece without reflective surface. i.e. wood or rough coated surface are acceptable.
Bright shiny reflective sheet or the like is not suitable for laser use as the reflective surface could direct the beam back at the operator.
• Do not change the laser light assembly with a di erent type. Any repairs must only be carried out by the laser manufacture or authorized service
agent.
• Do not attempt to repairs the laser guide by yourself.
• Do not attempt to change any parts of the laser guide.
• Always switch o the laser when not used.
4. RESIDUAL RISKS
Even when the power tool is used as prescribed it is not possible to eliminate all residual risk factors. The following hazards may arise in connection
with the power tool's construction and design :
•
Damage to lungs if an e ective dust mask is not worn.
•
Damage to hearing if e ective hearing protection is not worn.
•
Damage to health resulting from vibration emission if the power tool is being used over a longer period of time or not adequately managed and
properly maintained.
121 121
FR
ES
PT
IT
EL
PL
UA
RO
EN