Dexter 20VMPS2-85.1 Manual Del Usuario página 126

10. MAINTENANCE
FR
WARNING: Do not allow brake fluids, gasoline, petroleum-based products penetrating oils, etc... come In contact with plastic parts. They
ES
contain chemicals that can damage, weaken or destroy the housing, thus compromising the integrity of the double insulation.
A. GENERAL
PT
WARNING: Always remove the battery pack from the tool before carrying out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance.
Never use water or chemical cleaners to clean your power tool. Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working controls free of dust. Occasionally you may see sparks through the ventilation slots. This
IT
is normal and will not damage your power tool.
Replace the saw blade according to which material to saw, as soon as proper and e cient sawing is therefore no longer possible. Clean the
appliance after completing your sawing work. Remove any dirt (e.g saw dust).
EL
The ambient temperature range for tool and battery use and storage is 0°C to +45°C.
The recommended ambient temperature range for the charging system during charging is 0°C to +40°C.
The relative humidity of the area must be not more than 80% without direct exposure to rain and excessive dust content of the air.
After use, please store the saw blade with anti-rust oil, and put all accessories back into the package to avoid loss. If the parts are lost,
PL
please contact the store for repairs before use.
There are some user serviceable parts in your power tool. Please refer to the spare part list of the manual.
UA B. INSPECTING THE MOUNTING SCREWS
Regularly inspect all mounting screws and ensure that they are properly tightened. Should any of the screws be loose, tighten them immediately.
Failure to do so could result in serious injuries.
RO
C. MAINTENANCE OF THE MOTOR
The motor unit winding is the very "heart" of the power tool. Exercise due care to ensure the winding does not become damaged and/or wet with
oil or water.
EN
11. TROUBLE SHOOTING
PROBLEM
PRODUCT DOES NOT START
THE MACHINE STOPS WORKING
AFTER ROTATING SLOWLY
SPARKING VISIBLE THROUGH
THE HOUSING AIR VENTS
UNSATISFACTORY RESULT
LASER OR LED IS NOT WORKING
POSSIBLE CAUSE
Not connected to power supply
Power battery is defective
Other electrical defect to the product
The battery is low power
The battery is low power
Air vents are blocked
A small amount of sparking may be
visible through the housing vents
Saw blade is worn
As the laser is supplied by the UP20
battery, the laser has been damaged.
126
SOLUTION
Connect to power supply/Battery
Check by a specialist electrician
Check by a specialist electrician
Need to charge the battery pack before
operating
Need to charge the battery pack before
operating
Clean the air fans by blowing through the
air vents
This is normal and does not indicate a
problem
Replace with new saw blade
Check by a specialist electrician
126