Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT USE
RISK OF DAMAGE!
Close the 3-way valve and disconnect the product in case of water cut-off or pipe
maintenance. Always flush the water pipes after any maintenance work to prevent
larger debris from entering the filters.
If you do not plan to use the product for a long period of time, close the 3-way valve.
Before using the product again, open the 3-way valve and let the water run from
the tap for 3 to 10 minutes.
BUTTONS
Button (reset)
Button (discharge)
SIGNALS
LED filter indicators
MODE
Safe Mode
Self-cleaning mode
*Switched on
1. Connect the adapter and faucet to the cord connector on the unit, then plug the
plug into a 110-240V GFCI outlet.
2. All front panel indicators flash simultaneously for 5 seconds. After this the system
is being put into operation. The main unit will enter self-cleaning mode for 25
seconds. Do not use the tap during this time.
3. Once the product has completed the self-cleaning mode, it is recommended to
open the connected tap and let the water run for at least 20 minutes to rinse the
filters before drinking the water for the first time.
USE
4. Slowly turn the tap handle from its vertical position 90° anticlockwise to start the
water flow.
5. Turn the tap handle 90° clockwise to stop the flow of water. The amount of water
purified depends on the pressure and temperature of the water.
Press after replacing the filters (see MAINTENANCE
chapter).
Press to wash the newly installed filters.
When flashing, it indicates that it is time to change
the filters.
The product switches off automatically if the water
runs continuously for 30 minutes.
To reset it, close the tap and turn it off for a few minutes.
Turn it back on and the product will return to normal.
The product cleans the filters.
54
EN
Publicidad
