Coral OSMOSIS H600 Manual De Instrucciones página 55

MAINTENANCE
NOTE
The filter must be replaced when the corresponding indicator
starts flashing.
Both filters have a limited lifetime. Changes in the taste, odour,
colour and flow of the water being purified indicate that the filter
should be replaced.
To change a filter, proceed as follows:
1.
Close the 3-way valve (Fig.. 14).
2.
Open the drinking water tap to release the pressure.
3.
Disconnect the plug from the socket.
4.
Remove the main unit cover (Fig .15).
5.
Push up the locking lever. (Fig. 17).
6.
Pull upwards so that the filter comes out. (Fig. 18).
7.
Insert the new filter (The bottom of the filter should go into the
hole in the Base. (Fig. 19).
8.
Press the upper part of the filter into the corresponding hole.
(Fig.20).
9.
Push back the locking lever. (Fig.21 ).
10.
Install the front cover. (Fig. 22).
NOTE
Make sure that the PAC filter is on the left side and the carbon
filter on the right side, they are not interchangeable (Fig. 16).
FILTER REPLACEMENT
11. After the product has completed its start-up, press and hold
the (Reset) button for 3 seconds.
12. Turn on the tap and let the water run for at least 20 minutes
to wash the filters before drinking the water for the first time.
WARNING
Any other service not mentioned in this manual must be carried
out by an expert.
FILTER CHANGE MANUAL
13. Follow steps 1-12 above and then proceed as follows:
14. Press the (Reset) button to select the filter to be replaced. A
flashing indicator indicates which filter has been selected.
15. Once the correct filter has been selected, press and hold the
(Reset) button for 3 seconds until the indicator of the selected
filter remains lit.
16. Wash the new filter for at least 20 minutes.
55
EN