Zipper ZI-STE3000IV Instrucciones De Servicio página 37

14.2.4 Spark plug
14.3 Storage
Storage period up to 1 month:
No special preparation is required, only to check whether the fuel tap and the ON-OFF switch
•
are in the „OFF" position.
Storage period longer than one month:
• Drain the fuel. To do this, run the machine without any equipment connected.
• Set the fuel tap to the "OFF" position. The engine runs until the remaining fuel in the carburetor
is used up.
• Then switch the ON-OFF switch to position "0".
• Empty the fuel tank. To do this, drain the fuel and put it in a suitable container so that it does
not get into the environment.
• Store the drained fuel in a suitable container.
• When not in use, store the cooled down machine in a well-ventilated, dry, frost-proof and lock-
able place. Ensure that unauthorized persons and especially children do not have access to the
machine.
Improper storage can damage and destroy important components. Only store packed or al-
ready unpacked parts under the intended ambient conditions!
14.4 Disposal
Observe the national waste disposal regulations. Never dispose of the machine, machine com-
ponents or operating equipment in the residual waste. If necessary, contact your local author-
ities for information regarding available disposal options.
If you purchase a new machine or equivalent equipment from your specialist dealer, he is
obliged in certain countries to dispose of your old machine properly.
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
• Remove the spark plug cover (1).
• Remove the spark plug cap.
• Loosen the spark plug (2) using the spark plug spanner (3).
• Visually inspect the spark plug and remove carbon deposits
with a copper wire brush.
• Check electrode gap. This should be between 0,6 -0,7mm.
• If necessary, change the spark plug.
• Reassemble the spark plug in reverse order.
N O TE
37
ZI-STE3000IV