Stahlwille Standard MANOSKOP 720 Nf/80 Manual Del Usuario página 43

Adjusting for deviations in
cut-off value
You may return your torque wrench to
STAHLWILLE for adjustment. You will
then receive the tool back with a new
works calibration certificate.
You may adjust the torque wrench
yourself. In this case, however,
STAHLWILLE's accuracy guarantee is
void.
A torque tester of sufficient capacity and
accuracy is required for the inspection.
®
Every MANOSKOP has two adjusting
screws inside for readjustment purposes.
These are accessible with an Allen key,
size 2 mm, through two holes in the
housing.
The screw which is closest to the plastic
handle is primarily for adjusting the lower
end of the scale range.
The screw which is closest to the head is
primarily for adjusting the upper end of
the scale range.
Each screw has a minor effect on the
adjusting range of the other screw.
To protect the mechanisms from dirt,
these two holes are plugged.
43