Publicidad
Idiomas disponibles
Idiomas disponibles
USING THE APPLIANCE
DE
1.
Close the appliance and place the plug in a power socket (220–240 V~,
EN
50/60 Hz). The indicator lamp in the temperature control lights up.
2.
Turn the temperature control to the desired position between "Min" and
FR
"Max". Preheating begins, and the indicator lamp is lit red. Once the
NL
appliance has reached the pre-set temperature, the indicator lamp lights
up green.
IT
3.
Now, use a ladle to add batter to each cen-
tre of the lower baking surface. Always fill
ES
both baking surfaces to prevent damage to
the appliance.
PL
4.
The batter will spread evenly when you close
the appliance. Always make sure to add the
right amount of batter. If you add too little
batter, the top of the appliance will not be seated properly; the top side of the
waffles will then not be as brown as the bottom side. If the batter overflows,
the excess will be caught in the channel and baked as well. When baking is
complete, you can simply remove this surplus rim from the waffle.
5.
Close the appliance immediately after filling in batter to allow the waffle to
be browned evenly on the top and the bottom.
6.
The waffles are now being baked.
7.
Open the appliance carefully and remove the finished waffle. Refrain from
using metal objects as they might scratch the coating of the baking plates.
8.
If the waffle is not browned enough, close the appliance again and keep
repeating steps 5 through 7 until the waffle has been browned to your
satisfaction.
9.
Notice about the baking lights: When it is green, the indicator lamp signals
that the temperature has been reached again, but not that the waffle is
finished. The baking time of the waffle varies with the batter you use and
with your personal taste. Therefore, always check before taking the waffle out
if the waffle has been baked to your satisfaction. Our experience has shown
that Brussels Waffles are finished after baking for approx. 6 to 8 minutes.
10. To make more waffles, close the appliance and wait until the indicator lamp
lights up green. Proceed with steps 2 to 9 until you have used up all the
batter.
11. When finished baking, set the control to "0" and unplug the appliance. Only
then can you be sure the appliance is safely switched off.
Caution: The appliance will remain very hot for an extended time after use!
22 von 68
Stand 20.2.2023
Publicidad
