Publicidad
Idiomas disponibles
Idiomas disponibles
Every technical change has an
effect on the operation or sa-
fety of the appliance and must
therefore be performed by technical
personnel of the manufacturer or by
technicians who are formally authori-
sed by the same. Failure to do so
exempts the manufacturer from any
liability for for any possible resulting
modifications or damage.
Upon arrival, check the integrity
of the appliance and its compo-
nents (e.g. power cord), prior to
use. In the presence of faults do not
start the appliance and contact the
nearest service centre.
Read the instructions before
acting.
to be performed. As far as personal
protective equipment is concerned,
the European Community has issued
Directives which the operators must
comply with. Noise ≤ 70 dB.
It is forbidden the installation
of stand alone equipment WI-
THOUT anti-tip kit (ACCES-
SORY). TOP versions excluded.
Disconnect all supplies, if present
(e.g. water - gas - electrical) up-
stream the appliance whenever
you need to work in safe conditions.
Connect the appliance if pre-
sent, in the sequence of the
water, then to the gas network. Ensu-
re there are no leaks then proceed
with the connections to the mains.
Connect the appliance in the
sequence of the water, then to
the gas network. Ensure there
are no leaks then proceed with the
connections to the mains.
The appliance is not designed
to work in an explosive atmo-
sphere and as such its installa-
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
Wear
protective
equipment suitable
for the operations
- 5 -
tion and use is categorically prohibi-
ted in such environments.
Position the entire structure, re-
specting the installation dimen-
sions and characteristics indica-
ted in the specific chapters of this
manual.
The appliance is not intended
for recessed installation. / The
appliance must be used in a
well ventilated area. / The appliance
must have free drainage (not hinde-
red or impeded by foreign bodies).
The gas equipment must be in-
stalled beneath an extraction
hood whose system must have
specifications in compliance with the
current regulations in the country of use.
Once the appliance is connect-
ed to the power and drain
sources, it must remain static
(fixed) in the place of use and mainte-
nance. Incorrect connection may
cause danger.
Use where appropriate flexible
cable for connection to the
mains electricity supply with
characteristics not inferior to model
H07RN-F. The supply voltage sup-
ported by the cable with the appliance
working must not differ from the nomi-
nal voltage value ± 15% shown at the
bottom of the technical data table.
The appliance must be includ-
ed in an "Equipotential" ground
discharge system.
Drainage of the appliance must
be conveyed into the grey water
discharge network in an open
"glass" unsiphoned formation.
The appliance must only be
used for the purposes indicat-
ed. Any other use must be con-
sidered "IMPROPER" and therefore
the manufacturer declines all liability
for any consequent damage to per-
sons or property.
2.
EN
Publicidad
