Descargar Imprimir esta página

MBM IN74A Manual De Uso E Instalación página 40

Placas de cocción por inducción / wok
Ocultar thumbs Ver también para IN74A:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 71
Be careful when using the equip-
ment: glass cooktop. Do not use
the induction top as supporting surface.
Use containers with clean bottom, in
order to do not damage the plates'
surface and do not jeopardize the use.
In the event of prolonged inacti-
vity, besides disconnecting the
supply lines, you must thorou-
ghly clean all the inside and outside
parts of the appliance.
Wait for the temperature of the ap-
pliance and all its parts to cool off,
so that the operator is not burnt.
DAILY CLEANING OF ALL STEEL
COMPONENTS /
Use a standard sprayer to
apply the liquid detergent
on the whole surface of
the cooking compartment
and, using a non-abrasive
sponge, clean the entire surface thorou-
ghly by hand. When finished, rinse the
cooking compartment abundantly with tap
water (do not use pressurised direct
water or steam cleaners jets for cleaning
operations). When these operations have
been performed successfully, dry the
cooking compartment carefully using a
non-abrasive cloth. If necessary, repeat
the operations described above for a new
cleaning cycle.
DAILY CLEANING OF ALL GLASS
COMPONENTS /
Remove everything from
the cooking compart-
ment. Wait for the equip-
ment cooling. Do not use
pressurised direct water
or steam cleaners jets for cleaning ope-
rations. Put a pyroceramic specific de-
tergent on the concerned surface and
carefully clean it by a damp cloth. Wipe
the cooking area by a not abrasive cloth.
Repeat this operation, if necessary.
CLEANING THE AIR FILTER
Disconnect all power
supply sources. Un-
screw the drawer and pull
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
it out. Remove the grill and take the filter
out of the compartment. Wash the filter
with tap water and non-abrasive and/or
non-corrosive material to remove all
residues. Dry carefully. When finished,
put the filter and grill back in place.
Close the drawer completely and fasten
it to the panel.
Put the parts back in the cor-
rect positions and order
CLEANING FOR PROLONGED
DEACTIVATION
components. When the operations are
over, protect the parts more exposed to
oxidation
lukewarm water with a bit of soap to
clean the parts;
Rinse the parts thoroughly, without
using pressurised direct water or ste-
am cleaners jets for cleaning ope-
rations. Dry the surfaces carefully
using non-abrasive material. Wipe a
non-abrasive cloth lightly soaked with
food-safe Vaseline oil over all of the
stainless steel surfaces in order to
create a protective film.
For glass components, apply with a
soft cloth a layer of protective wax spe-
cific for the material.
Per concludere le operazioni vedere
cap. 5 / Messa fuori servizio
Air out the appliances and rooms
regularly.
SUMMARISED
QUENCY / TROUBLESHOOTING
Prima di procedere nelle opera-
zioni vedi cap.2 "Mansioni e
qualifiche"
Should a problem occur, the ge-
neric operator performs the first
search and, if qualified, elimina-
tes the cause of the problem and re-
stores the appliance correctly.
- 16 -
MAINTENANCE
When the appliance re-
mains idle for a long
time, perform all the de-
scribed daily cleaning
procedures. For steel
doing
as
follows.
TABLE:
Use
FRE-

Publicidad

loading

Este manual también es adecuado para:

In77aInw74aIn94aIn98aIn74tIn77t ... Mostrar todo