Publicidad
Idiomas disponibles
Idiomas disponibles
English
70°: Rotate the adapter (Figure 2 f.) in the same manner as
before to the 70° position. Slightly loosen the Phillips screw in
the cam wheel b. so that the wheel can be moved by hand.
Rotate the cam wheel b. clockwise until the switch button can
be seen. Then tighten-back the Phillips screw in the cam
wheel b.. Factory setting of auxiliary switches.
The two auxiliary switches a. and b. are factory set at the to
approximately 10° CW (a.) and 80° CW (b.).
Technical Specifications
Actuators
Drive Torque
Damper Area
Running Time
Power Supply
Frequency
Power Consumption:
- Operating 5.5 W
- At end stops 0.6 W
For wire sizing
Weight
Control Signals:
Position Signal
Angle of rotation:
- Working Range 90° (93° mech.)
Auxiliary Switch Rating
Sound Power Level
Protection Class
Degree of Protection
Temperature: Operating/Store
Humidity
Maintenance
Conformity
DMS2.5
8 Nm
1.5 m
30...45 s
Independent of load, at nominal conditions and room temperature
AC 230 V ±15%
50-60 Hz
6.0 VA / 0.1 A @ 2ms
1.2 kg
Y1 0(4)...20 mA / Ri > 100 KΩ
Y2 -
U DC 0(2)...10 V / R > 50 KΩ
- Limiting 5°...85° in 5° steps
3 (1.5) A, AC 230 V
45 dB (A)
II
IP 54 (with cable glands, cable downwards)
-20°...+50°C / -30°...+60°C
5...95% RH (not condensing).
Maintenance-free
EMC Directive 2004/108/EC:
EN 55011:2007
EN 55022:2006 A1:2007
EN 61000-3-2:2006
EN 61000-3-3:2008
EN 61000-4-2:2001
EN 61000-4-3:2006
EN 61000-4-4:2007
EN 61000-4-5:2006
EN 61000-4-6:2007
EN 61000-4-8 :1994 A1:2001
EN 61000-4-11:2004
EN 61000-6-1:2007
EN 61000-6-3:2007
IS_DMS2.5 / DM2.5 / DML2.5_14-88360-1947_Rev. C_01 2010
Ordering Codes
Codes
DM..2.5
DM..2.5S
DM2.5
16 Nm
2
80...110 s
This document is subject to change without notice
Descriptions
Actuator AC 230 V
Actuator AC 230 V with 2 auxiliary switches
3.0 m
2
Low Voltage Directive 2006/95/EC:
EN 60730-1A:2002
EN 60730-2-14:2002
DML2.5
24 Nm
4.5 m
2
125...160 s
2
Publicidad
