Publicidad
Idiomas disponibles
Idiomas disponibles
en-us Installation
Secure to the rear of the housing framework using six
2.
(6) x 1" (25.4 mm) mounting screws, as indicated below.
Secure to the top of the housing framework using eight
3.
(8) x 1"" (25.4 mm) mounting screws, 4 per side.
Connect to the ductwork.
4.
5.3 Blower motor installation
CAUTION
To reduce the risk of fire and electric shock, install this
range hood only with the blowers listed in the Ventilation
Planning Guide.
Note: Cutting the plug of the blower will void the warranty
or eligibility for return or exchange.
Installing the integral blower
Integral blower models are integrated into the hood at the
time of installation. Integral blowers should be installed
after the hood is mounted to the wall. For complete
installation instructions, see the instructions supplied with
the blower unit.
Note: Blower and hood image views vary depending on
model.
16
Thread one (1) 4m flange nut (included with the hood)
1.
half-way down each of the two weld studs indicated.
Slide the blower mounting plate behind the nuts on the
2.
weld studs.
Install two (2) 4m flange nuts (included with hood) to the
3.
top weld studs and tighten.
Tighten the two (2) nuts from step 1 to fully secure the
4.
blower to the hood.
Connect the blower's plug connector to the connector
5.
present inside the hood. Route the blower harness
through the self-locking clip.
Publicidad
