Publicidad
Idiomas disponibles
Idiomas disponibles
en-us Before you begin
2 Before you begin
Before you begin
Read these instructions before you begin to install your
Before you begin
appliance.
2.1 Important notes
WARNING
Improper installation of gas appliances and ventilation
hoods can create a risk for carbon monoxide which can be
harmful. To reduce the risk of carbon monoxide poisoning,
ensure the gas appliance is properly installed according to
the manufacturer's instructions, as well as ensuring the
hood is vented to the outside for proper exhausting of
gases or fumes.
Gas cooking appliances release carbon monoxide that
¡
can be harmful or fatal if inhaled. To reduce the risk of
fire and to properly exhaust air, the exhaust gases
extracted by the hood should be vented outside of the
building only.
Consult local building codes for requirements or
¡
restrictions related to installation of ventilation products
in recirculation mode.
Hood installation height above a cooktop, rangetop or
¡
range can vary. To obtain the necessary installation
height above a cooktop, rangetop or range, consult the
appliance's installation manual or combination matrix.
NOTICE:
The hood can be damaged from excessive heat if a range
or rangetop is operated with multiple burners at high
settings under a hood that is installed at minimum
clearances and is turned off.
2.2 Distance from cooking surface
The installation height above a cooktop, rangetop or range
is recommended as a minimum height of 30" (762 mm);
however, it is necessary to follow the cooking appliance
manufacturer's installation instructions for proper hood
height.
Refer to local building codes for the latest requirements or
restrictions when installing ventilation products in
recirculation mode.
2.3 Parts included
After unpacking all the parts, check for any damage in
transit and for completeness of delivery.
Metal transition with backdraft damper
¡
Baffle filters
¡
Grease trays
¡
Filter spacers
¡
Side trims
¡
Blower adapter
¡
Literature packet with fastener assortment
¡
Hardware provided is for mounting through standard
thickness drywall or plaster into wood studs. Installers
are responsible to provide hardware for other types of
mounting situations.
6
2.4 Tools and parts needed
Prepare these tools and accessories before you start to
install your appliance.
Blower (Refer to the Ventilation Planning Guide for
¡
compatible blowers)
Ducting as needed (Refer to table Equivalent duct
¡
lengths for commonly used transitions. → Page 11 )
Aluminum tape (DO NOT use insulating or cloth duct
¡
tape)
½" (13 mm) conduit if required
¡
Follow local codes
1" (25.4 mm) strain relief
¡
Cross head screwdriver
¡
T20 star bit screwdriver
¡
¹¹⁄₃₂" nut driver or socket and ratchet
¡
Drill with ³⁄₁₆" (4.76 mm) drill bit
¡
Circular saw or jigsaw
¡
Framing material (as necessary for framework)
¡
Wire stripper
¡
Measuring tape
¡
Pencil
¡
Level
¡
Safety gloves
¡
IMPORTANT: DO NOT throw away any packaging until
appliance is fully installed.
Optional accessories available for separate
purchase
Refer to www.thermador.com for details.
Accessory
Description
EXTNCB25W
25 ft. remote and in-line blower
extension cable
EXTNSET4
25 ft. remote and in-line blower
extension cable adapter kit
RFPLT600P
Roof plate for use with
600 CFM remote blower VTR630
¡
RFPLT1000P
Roof plate for use with
1000 CFM remote blower VTR1030
¡
1300 CFM blower VTR1330
¡
REMCPW
Remote control panel
Publicidad
