Publicidad
Idiomas disponibles
Idiomas disponibles
Access the hood's wiring. Route the 30 ft. extension
2.
harness through the strain relief to the square mounting
clip until it clicks.
Route the 30 ft. extension harness through the cutout
3.
and connect the harness to the back of the remote
control bracket.
Press the bracket inside the cutout. Drill a ¼" (6 mm)
4.
tap hole through the bracket holes into the wall. Mount
the bracket to the wall using the four (4) screws
provided.
Hook up the wire harness connector inside the bracket
5.
to the terminal on the back side of the remote control.
Use either terminal.
Snap the remote control into the bracket.
6.
5.6 Installing the grease trays and filters
IMPORTANT: DO NOT use the cooktop, rangetop, or
range while the hood is disassembled.
Custom insert hood
VCINxxGWx
1
3
4
Installation en-us
2
5
6
19
Publicidad
