Publicidad
Idiomas disponibles
Idiomas disponibles
en-us
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
When the service panel cannot be locked, securely
fasten a prominent warning device, such as a tag to the
service panel.
Do not repair, replace or remove any part of the appliance
unless specifically recommended in the manuals.
Improper installation, service or maintenance can cause
injury or property damage.
▶
Refer to this manual for guidance.
▶
All other servicing should be done by an authorized
service provider.
WARNING
ELECTRIC SHOCK HAZARD
▶
Disconnect power before installing or servicing. Before
turning power ON, be sure that all controls are in the
OFF position.
▶
DO NOT remove connections.
DO NOT use an extension cord.
▶
Improper grounding can result in a risk of electric
▶
shock.
▶
Failure to follow these instructions can result in death,
fire, or electrical shock.
GROUNDING INSTRUCTIONS
This appliance must be grounded.
▶
▶
Grounding reduces the risk of electric shock by
providing a safe pathway for electric current in the
event of a short circuit.
▶
Be sure your appliance is properly installed and
grounded by a qualified technician.
▶
Installation, electrical connections and grounding must
comply with all applicable codes.
If required by the National Electrical Code (or Canadian
¡
Electrical Code), this appliance must be installed on a
separate branch circuit.
WARNING
To reduce the risk of fire or electric shock, do not use this
appliance with any solid-state speed control device.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING.
Installation work and electrical wiring must be done by
▶
qualified person(s) in accordance with all applicable
codes and standards, including fire-rated construction.
4
Sufficient air is needed for proper combustion and
▶
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent back drafting. Follow the
heating equipment manufacturer's guideline and safety
standards such as those published by the National Fire
Protection Association (NFPA), and the American
Society for Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code authorities.
When cutting or drilling into wall or ceiling, do not
▶
damage electrical wiring and other hidden utilities.
▶
Ducted fans must always be vented to the outdoors.
▶
USE ONLY METAL DUCTWORK.
DO NOT vent exhaust air in spaces with walls or
▶
ceilings or into attics, crawl spaces or garages.
CAUTION
For general ventilating use only.
Do not use to exhaust hazardous or explosive materials
▶
and vapors.
WARNING
Never modify or alter the construction of the appliance.
WARNING
Remove all tape and packaging before using the
appliance.
Dispose of packaging in an environmentally responsible
▶
manner.
Never allow children to play with packaging material.
▶
WARNING
Unit is heavy and requires at least two people or
proper equipment to move and install.
WARNING
Hidden surfaces may have sharp edges.
Use caution when reaching behind or under appliance.
▶
CAUTION
An outside fan is to be mounted behind louvers or in a
location where the entrance of drawn in water is unlikely.
1.4 Safety codes and standards
This appliance complies with the latest version of one or
more of the following standards:
UL 507 - Electric Fans
¡
CAN/CSA C22.2 No. 113 - Fans and Ventilators
¡
Publicidad
