Use Of The On-Board Battery Charger; Starting Of The Machine; Operations To Make For Correct Use - Tennant 3610 Manual Del Operador

A) CONTROL PANEL
B) CHARGER FUSE (2,5A)
C) HANDLE LOCKS
D) BUMPER
E) SIDE BRUSH
F) TOP COVER
G) WARNING LABEL
H) CHARGER CORD COMPARTMENT
I) HOPPER
J) BRUSH
FUSE 2,5A
Home Find... Go To..
USE OF THE ON-BOARD BATTERY
CHARGER:
When the battery on the machine is discharged, the red
led on the control panel illuminates and all functions of
the machine will automatically stop: the operator must
then turn off the machine and start the charging proce-
dure by connecting the machine battery charger plug into
an AC electrical outlet. (during charging the yellow led on
the display will be lit): when the machine is fully charged
the green led will be lit, the battery charger plug can be
disconnected and the machine is ready for operation.
IMPORTANT NOTE: USING THE MACHINE BEFORE
THE BATTERY HAS FULLY CHARGED AND A
GREEN LIGHT DISPLAYED WILL REDUCE THE LIFE
AND RUN TIME OF YOUR BATTERY AND VOID THE
WARRANTY. The on-board charger
designed for Sealed batteries.
NOTE: If during working mode the machine battery
charger plug is connected, the machine will automatically
stop all its functions. Such operation is forbidden.

STARTING OF THE MACHINE:

ATTENTION: the machine must be used only by
authorized personal, DO NOT ABANDON the machine
when switched on, do not use the machine for collecting
liquid, turn the machine OFF before leaving the machine.
FOR SAFETY: DO NOT OPERATE MACHINE UNLESS
OPERATION MANUAL IS READ AND UNDERSTOOD
To start the machine use the following procedures:
- Press the main ON/OFF button
- Check the that the green led is lit indicating a proper
battery charge level
- Select the appropriate sweeping mode
ON/OFF sweeping mode button 1 - for light debris and
smooth surfaces
ON/OFF sweeping mode button 2 - for heavy debris and
concrete, asphalt and carpeted surfaces. Notes: using
sweeping mode 2 will reduce the maximum machine run
time.
OPERATIONS TO MAKE FOR CORRECT
USE:
After having followed all operations for starting the
machine you are now ready to work with the machine as
a sweeper. To achieve the maximum performance follow
the proceedures in this manual to avoid the risk of
damaging the machine.
It is important:
- Not to use the machine for collecting wires, ropes,
strings, water or other liquids .
- In the presence of large volume debris (paper, leaves,
etc.) raise the front part of the machine by pushing down
the handle bar. Shake the filter at the end of the working
5
i
s specifically