Publicidad
MULTI-FUNCTION DISPLAY
2. Start timer measurement by pushing the
"RST" button.
3. When stopping timer measurement, push-
ing the "SLCT1" button and "SLCT2" button
at the same time.
NOTE:
If the machine is run while timer measurement
is not made, no change will occur to the digit in
tripmeter A (TRIP A).
4. To resume the measurement, again push
the "SLCT1" button and "SLCT2" button at
the same time.
Auto start
1. Check that changeover has been made to
RACE MODE. (Refer to "Changeover from
BASIC MODE to RACE MODE".)
2. Make the machine ready for a run by push-
ing the "SLCT1" button for 2 seconds or
more.
NOTE:
When measurement is made ready for a run
by auto start,
Timer display will turn on scrolling from left to
right.
3. Run the machine and start timer measure-
ment.
4. To stop timer measurement, pushing the
"SLCT1" button and the "SLCT2" button at
the same time.
NOTE:
If the machine is run while timer measurement
is not made, no change will occur to the digit in
tripmeter A (TRIP A).
5. To resume the measurement, again push-
ing the "SLCT1" button and "SLCT2" button
at the same time.
1 - 18
GEN
INFO
and
will start flashing.
Publicidad
Capítulos
