Kärcher KM 100/120 R G Manual Del Usuario página 34

Device fuses (overview)
Fault
Motor will not start
Motor running irregularly
Engine is running, but the de-
vice does not drive or just
slowly
Motor does not switch off
(programme selector switch
and key switch are in the OFF
position)
Dust when sweeping / insuffi-
cient suction power
34
Rectification
 Check/charge the starter battery.
 Key switch to position "I - ON".
 Programme selector switch to "Drive" position
 During cold exterior temperatures: Operate the choke lever.
 Sit in the driver's seat (seat contact switch is activated).
 Fully close the bonnet and right panel.
 Check motor oil level, top up motor oil if necessary.
 Fill with fuel.
 Open the fuel cock.
 Check spark plug.
 Check the filling level of the fuel tank.
 Check the position of the choke lever.
 Check connections and lines of fuel system.
 Check/clean/replace spark plug.
 Clean/replace the air filter.
 Release the parking brake.
 Check the position of the neutral lever.
 Check/top up the filling level of the hydraulic oil tank.
 In the event of freezing temperatures and cold hydraulic oil: Allow the device to warm up for at least
3 minutes.
 Petrol engine:
a Open the bonnet (be careful of the rotating V-belt).
b Close the fuel cock.
 Empty the waste container.
 Check / clean / replace the dust filter.
a Check that the dust filter is firmly in place.
b In case of light soiling, clean the dust filter.
c In case of damage or heavy soiling, replace the dust filter.
 Check the sealing strips in the sweeping area to check for wear. Readjust or replace if necessary.
 Check/replace the seals on the filter box.
 Check/replace sealing strips on waste container.
A: Fuses on the electronic controller
Device fuse
F100H
F102H
F103H
F104H
F105H
F106H
F107H
F109H
F110H
F111H
F112H
F113H
F114H
F200H
F201H
F205H
F207H
F209H
F212H
F213H
B: Fuses in the wiring harness (fuse holder)
Device fuse
F1 (M9)
F2 (M8)
F3 (M11)
English
Value (A) Designation
7.5 Key-operated switch
7.5 Work light
7.5 Water pump
3 LED
7.5 Work light
3 Blue spot
1 Counter
5 Filter motor
7.5 Signal horn
10 Lifting motors
5 Start the motor
1 Flashing beacon
1 Position sensor,
emptying
30 Main fuse
3 K1 Main valve
3 K4 Sweeper units
3 K6 Open flap
3 K3 Close flap
3 K5 Lift
3 K2 Lower
Value (A) Designation
7.5 Lifting motor
7.5 Lifting motor
7.5 Lifting motor