WEG CFW500 Manual Del Usuario página 47

Technical Specifications
Outputs Relay
(*)
Transistor
Power supply
Communication Interface RS485
Safety Protection
Human-machine Standard HMI
interface (HMI)
Enclosure IP20
Nema1/IP20
(*) The number and/or type of analog/digital inputs/outputs may vary. Depending on the Plug-in module (accessory) used.
For the table above, it was considered the standard plug-in module. For further information, refer to the programming
manual and the guide supplied with the optional item.
(**) The maximum capacity of 150 mA must be considered adding the load of the 24 V power supply and transistor output,
that is, the sum of the consumption of both must not exceed 150 mA.
42 | CFW500
1 relay with NA/NF contact
„
Maximum voltage: 240 Vac
„
Maximum current: 0.5 A
„
Programmable functions
„
1 insulated digital output open sink (uses as reference the 24 Vdc
„
power supply)
Maximum current 150 mA
„
power supply
Programmable functions
„
24 Vdc -15 % + 20 % power supply. Maximum capacity: 150 mA
„
10 Vdc power supply. Maximum capacity: 2 mA
„
Insulated RS485
„
Modbus-RTU protocol with maximum communication of
„
38.4 kbps
Overcurrent/phase-phase short circuit in the output
„
Overcurrent/phase-ground short circuit in the output
„
Under/overvoltage
„
Overtemperature in the heatsink
„
Overload in the motor
„
Overload in the power module (IGBTs)
„
External alarm/fault
„
Setting error
„
9 keys: Start/Stop, Up arrow, Down arrow, Direction of Rotation,
„
Jog, Local/Remote, BACK/ESC and ENTER/MENU
LCD display
„
View/edition of all parameters
„
Indication accuracy:
„
- current: 5 % of the rated current
- speed resolution: 0.1 Hz
Models of frames A, B, C, D and E
„
Models of frames A, B, C, D and E with kit NEMA1
„
(maximum capacity of the 24 Vdc)
(**)
(**)