Gun Handle Disassembly - Lincoln Electric POWER MIG 216 Manual Del Usuario

D-3

GUN HANDLE DISASSEMBLY

The internal parts of the gun handle may be
inspected or serviced if necessary.
The gun handle consists of two halves that are
held together with a collar on each end. To
open up the handle, turn the collars approxi-
mately 60 degrees counterclockwise (the same
direction as removing a right hand thread) until
the collar reaches a stop. Then pull the collar
off the gun handle. If the collars are difficult to
turn, position the gun handle against a corner,
place a screwdriver against the tab on the col-
lar and give the screwdriver a sharp blow to
turn the collar past an internal locking rib.
Counterclockwise
MAINTENANCE
ACCESSORIES AND EXPENDABLE REPLACEMENT PARTS
FOR MAGNUM 250L GUN AND CABLE ASSEMBLIES
Description
CABLE LINER
For 15' (4.5 m) or
shorter Cable
CONTACT TIPS
Standard Duty
Heavy Duty
Tapered
Tab (For Aluminum) KP2010-5B1
GAS NOZZLES
Fixed (Flush)
Fixed (Recessed)
Requires: Gas
Diffuser As'bly
Adjustable Slip-On
Requires:
Nozzle Insulator
Asʼbly
Requires:
Gas Diffuser
Asʼbly
Gasless Nozzle
(For Innershield)
GUN TUBE ASSEMBLIES
Standard (60°)
45°
* Included with POWER MIG® 216
Δ Requires KP52 Gas Diffuser Assembly.
POWER MIG® 216
TABLE D.2
English
Part No. Size
KP42-25-15 .025" – .030"
KP42-4045-15 .035" – .045"
KP42-4045-15 3/64"
(Alum. wire)
KP14-25 .025"
KP14-30 .030"
KP14-35* .035"
KP14-45 .045"
KP14H-35 .035"
KP14H-45 .045"
KP14T-25 .025"
KP14T-30 .030"
KP14T-35 .035"
KP14T-45 .045"
3/64"
(Alum. Wire)
KP23-37F 3/8"
KP23-50F* 1/2"
KP23-62F 5/8"
KP23-37 3/8"
KP23-50 1/2"
KP23-62 5/8"
KP52-FN * .025" – .045"
KP22-50 1/2"
KP22-62 5/8"
KP32
KP52-23 .025" – .030"
KP52 .035" – .045"
KP1947-1 Δ
KP2015-1 *
KP2041-1
D-3
Metric
Size
0.6 – 0.8 mm
0.9 – 1.1 mm
1.2 mm
(Alum. wire)
0.6 mm
0.8 mm
0.9 mm
1.1 mm
0.9 mm
1.1 mm
0.6 mm
0.8 mm
0.9 mm
1.1 mm
1.2 mm
(Alum. Wire)
9.5 mm
12.7 mm
15.9 mm
9.5 mm
12.7 mm
15.9 mm
0.6 – 1.1 mm
12.7 mm
15.9 mm
0.6 – 0.8 mm
0.9 – 1.1 mm