Remote Control - Winix PlasmaWave 5300 Manual De Usuario

REMOTE CONTROL

PREPARATION
• Press and slide the back cover of the
remote to remove.
• Insert batteries as shown.
• Close the back cover.
BATTERY USE
• The batteries for the remote control are
for initial use only. Change the batteries
when necessary.
• When replacing the batteries, replace
both at once with 2 new AA batteries.
• Incorrect battery usage may cause
battery fluid leakage and/or damage.
• When not using the remote control for
an extended period of time, remove the
batteries.
• Avoid dropping or damaging the remote
control. Keep remote control away from
direct sunlight or heaters.
USING THE REMOTE CONTROL
Proper conditions
• Operate the remote control facing the
air cleaner.
• Operate within 20 feet of the air cleaner.
Poor conditions that may impair
operation
• Any location where there is inverter
lighting equipment or electronic
spontaneous lighting equipment.
• When objects or furniture are located
between remote and air cleaner.
• When air cleaner unit is located in direct
sunlight.
• In areas where fluorescent lighting is
flickering due to worn out bulbs.
POWER
Use the POWER button to turn the power
on and off. A short "beep" will sound
when you turn the unit on or off. Once
the unit is on, it will automatically switch
into Automatic operation. Turn the unit to
manual control by pressing one of the
FAN CONTROL buttons.
FAN CONTROL
• UP
Use this button to switch from
Automatic operation and increase the
fan speed level.
• DOWN
Use this button to decrease the fan
speed level.
TURBO
Use this button to switch from
Automatic operation and begin the
maximum amount of room cleaning
and air movement.
PLASMA ON/OFF
Use this button to turn the
PlasmaWave TM generator on or off.
8
POWER button
PLASMA ON/OFF
button
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference through one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that
to which the receiver is connected.
• Consult an experienced radio/TV technician for help.
TURBO button
FAN CONTROL
buttons
9