Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATIONS FOR USE
INSTALLATION LOCATION:
1. Ventilation condition
The position you select for the refrigerator installation should be well-ventilated and has less hot air.
Do not locate the refrigerator near a heat source such as cooker, and avoid it from direct sunlight,
thus guaranteeing the refrigeration effect while saving energy consumption. Do not locate the
refrigerator in the damp place, so as to prevent the refrigerator from rusting and leaking electricity.
The result of the refrigerant charge amount of the refrigerator being divided by the total
space of the room in which the refrigerator is installed shall be less than 8g/ m³.
Note: The amount of refrigerant charged for the refrigerator can be found on the nameplate.
2. Heat dissipation space
When working, the refrigerator gives off heat to surroundings. Therefore, at least 30mm of free space
should be spared at the top side, more than 100mm on both sides, and above 50mm at the back
side of the refrigerator.
Dimensions in mm:
W
D
H
A
B
C(°)
E
F
710
770
1855
1297
1407
130±5
50
100
Note: Figure 1, Figure 2 only illustrate the space demand of the product.
3. Level ground
Place the refrigerator on the solid and flat ground (floor) to keep it stable, or else, it will give rise to
vibration and noise. When the refrigerator is placed on such flooring materials as carpet, straw mat,
polyvinyl chloride, the solid backing plates should be applied underneath the refrigerator, so as to
prevent color change due to heat dissipation.
Unobstructed ventilation shall be maintained around the appliance or in an embedded structure.
PREPARATIONS FOR USE
1. Standing time
After the refrigerator is properly installed and well cleaned, do not switch it on immediately. Make
sure to energize the refrigerator after more than 4 hour's standing, so as to ensure its normal
operation.
46
Publicidad
