Publicidad
Idiomas disponibles
Idiomas disponibles
Note: If the above descriptions are inapplicable to troubleshooting, do not disassemble and
repair it yourself. Repairs carried out by inexperienced persons may cause injury or serious
malfunctioning. Contact the local store where your purchase was made. This product
should be serviced by an authorized engineer and only genuine spare parts should be used.
When the appliance is not in use for long periods, disconnect from the electricity supply, empty all
foods and clean the appliance, leaving the door ajar to prevent unpleasant smells.
REVERSING THE DOOR
To dismantle the refrigerator door.
a) Use a tool to remove the screws from the
upper hinge cover, remove the upper
hinge, and install the communication wire
into the hole on the top of the refrigerator.
b) Screw off the three bolts on the upper
hinge, remove the upper hinge, and pry off
the upper hinge cover, door sleeve,
magnet.
c) Put the door communication wire into the
hole on the door, and then cover it.
d) Remove the three bolts from the hinge
cover
on
the
refrigerator, remove the hinge cover, take
out the wire harness in the hole, and install
the door shaft sleeve.
left-side
top
of
e) Lift the refrigerator door up by 50mm to
remove the refrigerator door.
f)
Remove the left front adjustable foot,
screw off the 5 screws fixing the hinge with
a tool, and then remove the hinge
assembly.
g) Relocate the door stopper and the lower
hinge shaft to the left side of the hinge.
Follow the steps below:
1) Remove the screw fixing the stopper
with a cross screwdriver;
2) Remove the nut and washer fixing the
the
hinge shaft with a wrench
55
Publicidad
