Chauvin Arnoux SIMPLE LOGGER II Serie Manual De Usuario página 56

SIMPLE LOGGER II
3. Yellow LED
ORDER
OFF
Single flash
STATUS
Double flash
Rapid flash
4. Red LED
ORDER
OFF
Single flash
STATUS
Double flash
Rapid flash
5. Blue LED
ORDER
OFF
STATUS Single flash
Double flash
* To determine whether the device is off or in standby mode, press the "PRESS" button for 0.5 second: if all
of the LEDs light, the device is not off.
Note: The overload warning appears as soon as an input quantity exceeds by 10% the
specified value of the input range.
When the battery voltage falls below 1.7 volt, the device stops automatically (if a recording is in progress, it is
stopped and the data are saved).
Sleep mode: The device switches to low-consumption mode after one minute with no press of the button
and remains in this mode for as long as the button is not pressed or until the time at which programmed
recording is to be started is reached.
Recording mode: The device switches to low-consumption mode between measurement acquisition stages.
The lower the recording frequency, the larger the fraction of the time spent in low-consumption mode, and so
the longer the possible total recording time.
OFF mode: The device is in low-consumption mode; it will switch on automatically to start programmed
recording.
CLEARS THE ALARM DISPLAY
Lit
No alarm detected (all channels)
There has been an alarm in at least one
channel at least once
There is currently an alarm in at least one
channel
Ready to clear alarm indications
Lit ERASES THE MEMORY
No data in memory
Memory partially filled
Memory full
Ready to erase the memory
Lit
Battery voltage OK (> 2.2 volts)
Batteries worn, must be replaced (< 2.2
volts)
Confirms the programming of a recording
(see § 4.6)
(see § 4.7)
STOPS THE DEVICE
English
Page 56