Stahlwille Manoskop 730D Serie Instrucciones De Servicio página 38

EN
Mounting an insert tool

Insert the insert tool into the wrench head's square
socket.
When doing this, the spring-loaded retaining pin of the
insert tool's QuickRelease safety locking mechanism
is pressed down by the insert slope.

Continue pushing the socket tool in to the stop.

Make sure that the retaining pin jumps into the
detent bore of the QuickRelease safety locking
mechanism.

Check that the insert tool is securely seated.

For controlled, counter clockwise tightening with
cut-out, connect the socket tool, rotated by 180°,
with the torque wrench.

If a ratchet insert is used, switch this to the desired
operating direction by turning the selector disk.

Position the appropriate socket onto the square
drive of the reversible ratchet until it engages
audibly.
12
Removing an insert tool
Insert tool installed "normally"

Press the green QuickRelease button on the lower
side of the wrench head (A).

Pull the insert tool out (B).
Socket tool installed rotated by 180°

Insert a thin drift from the outside into the detent
bore on the upper side of the wrench head.

Use the drift to press the retaining pin down (A).

Pull the insert tool out (B).