Cherubini BLUE BUS TDS Serie Instrucciones página 31

COMMANDS FROM A REMOTE CONTROL (BLUE BUS TDS RX)
It is possible to control the Blue Bus TDS RX control unit by means of a Cherubini remote control. Follow
the instructions shown in the following pages for programming. As far as all programming sequences
are concerned, we recommend also consulting the remote control instruction leaflet.
COMMAND SEQUENCES EXAMPLE (BLUE BUS TDS RX)
Most of the command sequences have three distinct steps, at the end of which the motor indicates if
the step has been concluded positively or not, by turning in different ways. This section is provided to
demonstrate the motor indications. The buttons must be pressed as shown in the sequence, without
taking more than 4 seconds between one step and the next. If more than 4 seconds are taken, the
command is not accepted and the sequence must be repeated.
Command sequence example:
A
+ B
Step 1
As we can see from the example, when the sequence ends positively, the motor returns to its starting
position in one long rotation. In fact, two short rotations in the same direction correspond to one long
rotation in the opposite direction. The motor returns to the starting position even when the sequence is
not completed; in this case by performing one or two short rotations.
Example of a wrong sequence:
A
+ B
Step 1
A
+ B
Step 1
B
Step 2
> 4 sec
B
Step 2
31
B
repeat the
sequence
> 4 sec
Step 3
repeat the
sequence