Cherubini BLUE BUS TDS Serie Instrucciones página 32

SETTING THE FIRST REMOTE CONTROL (BLUE BUS TDS RX)
This operation can only be performed when the control unit is new, or after a total delete of the memory.
During this step, power up only one control unit at time!
T1: First remote control to be set
A
+ B
T1
Every time you connect the power supply to the control unit, you have 3 hours to store the first
remote control. After this time, the ability to store the remote control is disabled. To reset the timer
of the function you have to disconnect and reconnect the power supply to the control unit.
SETTING THE ROTATION DIRECTION OF THE MOTOR (BLUE BUS TDS RX)
This operation is necessary if the rotation direction of the motor does not match to the UP and DOWN
buttons of the remote control or of the control switch.
If a Wind-sensor is connected, it's absolutely necessary and important to set the rotation direction. (To
avoid damage of the awning!!)
Setting the rotation direction using the button RESET/AUX:
Interchanging the brown and black motor wire on the terminals of the control unit, will also reverse
the rotation direction.
The control unit will keep this setting even after complete memory clearing!!
B
AUTOMATIC DISABLING OF THE FIRST
REMOTE CONTROL SETTING FUNCTION
T1
max 2 sec
32
B
T1 (2 sec)