ResMed Air10 Manual De Instrucciones página 2

English | Deutsch | Français | Italiano | Español | Português | Nederlands | Svenska | Dansk | Norsk | Suomi |
Česky | Eesti | Lietuvių kalba | Polski | Română | Русский | Slovenščina | Türkçe | Ελληνικά | Latviešu | Български
C
B
ENGLISH
The Air10™ DC/DC Converter 90W (model no. 370003)
allows you to operate your device from a vehicle cigarette
lighter socket (12V or 24V DC power source) in a car, boat,
or other vehicle equipped with a suitable battery.
The Air10 DC/DC Converter 90W (model no 370003) is
specifically for use with the AirSense™ 10, AirCurve™ 10
and Lumis™ device.
Consult your equipment supplier for more information
about this accessory.
Using the converter via a vehicle cigarette
lighter socket
Refer to Illustration at the beginning of this document.
1. Before connecting the converter, make sure the
converter switch (A) is off.
2. Position the converter on a level surface, with the
ResMed logo facing up.
3. Plug the converter connector (B) into the device power
inlet/DC input socket (C).
4. Remove the cigarette lighter from the vehicle cigarette
lighter socket.
5. Plug the converter adaptor plug (D) into the vehicle
cigarette lighter socket.
6. Switch on the converter. The light (E) will glow green
when it powers on.
The light will flash continuously if the connection is not
made, or if the device is in standby or power save mode
3781086 Air10 DC-DC Converter 90W User Guide.indd 1 3781086 Air10 DC-DC Converter 90W User Guide.indd 1
E D A
Notes:
• Some vehicles require the ignition key to be turned
• If you connect your device to a powered converter, the
• The power cord is not replaceable.
• If the battery OR car, boat or other vehicle are not in
• The Air10/ Lumis device with the HumidAir
• If the converter cuts power to your device when
• When the converter is not in use switch the converter
• If you need help, contact a ResMed representative,
Cleaning
If necessary, wipe the outside of the converter with a
clean, damp cloth.
• Read instructions before use.
• Only use the converter when connecting to a 12V or
• Do not attempt to modify the converter. There are
• The Air10 DC/DC converter must only be used with
• The converter is intended for use on 12V or 24V
Air10 DC/DC Converter 90W
| Magyar |
简体中文
when the connection is made. If the battery is low,
the light will glow amber. If the light does not operate,
check that the converter switch (A) is on.
to the "accessories" position to provide power to the
vehicle cigarette lighter socket.
converter may power down. To resume power, turn the
converter off and on again.
good condition, there may not be enough reserve left in
the battery to start the vehicle after use.
attached uses considerably more power than the Air10/
Lumis device alone. Using the HumidAir humidifier will
drain the battery more quickly.
starting your car, boat or other vehicle, disconnect the
converter from the vehicle. Wait a few seconds and
then reconnect it.
off or disconnect it from the vehicle cigarette lighter
socket to prevent battery discharge.
ResMed Technical Services or see www.resmed.com.
WARNINGS
24V DC supply.
no user-serviceable parts inside the converter.
CAUTIONS
AirSense 10/ AirCurve 10/ Lumis devices to ensure
proper performance.
negative ground systems (where the negative
terminal of the battery is grounded). Using it on a
12V or 24V positive ground system may damage
the converter and the vehicle's electrical system. If
you are unsure whether you have a negative ground
system, consult the car, boat or other vehicle
manual.
User Guide
| ‫العربية‬
| |
日本語
繁體中文
humidifier
™
23/03/2023 10:16:50 AM 23/03/2023 10:16:50 AM