Publicidad
Idiomas disponibles
Idiomas disponibles
2.BEFORE OPERATION
2.1.Power Supply
1)Batteries Installation
Open the camera by unlocking latch firstly. The battery
compartment is the right part of the camera. Open the protective
cover of the battery compartment and insert 4 x 1.5 V LR6/AA
batteries into the battery slots. Make sure insert each battery
with correct polarity(+ and - end against the long spring of each
battery slot). To increase the operating time, you can use 8 x 1.5
V LR6/ AA batteries. When using 4 batteries, they all should be
installed in the top 4 slots or the bottom 4 slots.
NOTES:
● NEVER INSTALL DIFFERENT TYPES OF BATTERIES or
MIXED NEW AND OLD BATTERIES in the product at the same
time.
● Anytime you load or unload batteries, make sure that the
camera is OFF. If using an external power source, remove the
internal battery.
2)Using an External Power Source
Optionally, you can connect an external 6V 1.5~2.0 A DC
power-source to the DC jack at the bottom of the camera. The
power connector is a 3.5 x 1.35 mm
coaxial DC power plug with positive
'tip' (inside pin) polarity.
Please notice that the external power
source does not supply power to the
batteries in the battery compartment
8
English
2.BEFORE OPERATION
Publicidad
