HAPIMP PH810W Manual De Instrucciones página 36

2) Use the bracket
You can mount the camera permanently on a wall or tree using
the supplied wall bracket. Before mounting the wall bracket you
should ensure that all screws are tight.The best distance from
the ground is about 1 meter.
Components
1.Tripod screw
2.Lock nut
3.Pivot bolts
4.Drill holes
5.Hexagonal screw
6.Wall plugs
7.Screws
Mounting the wall bracket Required tools
● Drill
● 6 mm masonry/concrete drill bit
● Phillips head screwdriver
NOTE:
■ Ensure that there are no electric lines, water, or heating pipes
installed at the proposed drilling location!
■ The supplied wall plugs are only suitable for mounting on
concrete or stone. Before starting the installation, please check
your installation location carefully for its suitability for the plugs.
The assembly material used must be suitable for the respective
location. If in doubt, consult a professional.
STEPS:
♦ Mark the drill holes by holding the foot of the wall bracket at
the desired mounting location and marking the hole positions.
30
English 7.MOUNTING GUIDE