Publicidad
Idiomas disponibles
Idiomas disponibles
♦ Use a drill with a6 mm drill bit to drill the required holes and
insert the plugs and insert the wall plugs flush with the wall.
♦ Screw the wall bracket to the wall using the supplied screws.
♦ Mount the camera on the tripod screw and screw the camera
a little way on (about three turns).
♦ Turn the camera in the desired direction and lock it with the
lock nut.
♦ To move the camera into its final position, undo the two
pivot bolts a little, position the camera, and fix the position by
tightening the two pivot bolts through the hexagonal screw.
If you have any questions, please contact our after-sales
mailbox.
7.2.Align the Camera
In test mode you can adjust the optimum exposure angle and
the range of the motion sensors.During alignment, consider
whether the use of the side motion sensors may be useful for
attaining the desired observation results. You can activate/
deactivate the side
motion sensors using the above-described menu.
Please adjust the camera as follows:
1)Fasten the camera to a tree or similar object a height of 1-2
meters and align the camera in the desired direction.Then move
slowly from one side of the target area to the other side.While
doing this, monitor the motion display.
2)If this lights tum blue,you are detected by one of the activated
side motion sensors.If lights turn red,you are detected by the
front motion sensor.By this way,you can align the camera to the
best angle and distance.
During normal operation, there will be no LED display in this
case.
7.MOUNTING GUIDE
31
English
Publicidad
