Terminating The Charging Process; Multi-Function Button; Terminating Charging And Acknowledging Faults; Restarting Residual Current Devices And Miniature Circuit Breakers - Mennekes AMTRON E Start Manual De Instrucciones Y De Instalación

7.2.3 Terminating the charging process

T
T
ATTENTION
Damage to the charging cable
Tensile stress of the charging cable may cause cable
breaks and other damage.
f Only pull the charging cable directly from the socket
outlet.
f End charging process in a controlled manner (e.g. with
multi-function or stop button or on the vehicle).
f Pull the charging cable out of the charging socket on
the plug.
f Fit on the protective cap.
f Hang or store the charging cable kink-free.
For a type 1 charging connector, press the release
button to unplug.
Charging cable cannot be removed
If the charging plug cannot be removed, e.g. after a power
failure, the charging plug could not be unlocked in the
device. The charging plug cannot be removed and must be
unlocked manually.
f Have the charging plug unlocked by a qualified electri-
cian.
Î "9.3 Unlocking the charging plug"
7.3

Multi-function button

Only available for the equipment variants Light, Pro and
Basic (R).

7.3.1 Terminating charging and acknowledging faults

Fig.: 22. Terminating charging and acknowledging faults
Terminating a running charging process (only for devices
without key switch) and acknowledging faults.
f Press the multi-function button (about 10 mm).
The charging process is terminated and the charging
9
plug in the device is unlocked.
7.3.2 Restarting residual current devices and miniature
circuit breakers
Fig.: 23. Restarting
The residual current device and the miniature circuit break-
er in the device can be manually switched on again from
outside via the multi-function button, without opening the
housing.
f Press the multi-function button up to the end position
(> 15 mm).
9 Residual current device and miniature circuit breaker
are switched on again.
EN
23