Scope Of Delivery - Benning CM 2 Instrucciones De Servicio

2. Safety note
The instrument is built and tested in accordance with
DIN VDE 0411 part 1/ EN 61010-1
DIN VDE 0411 part 2-032/ EN 61010-2-032
DIN VDE 0411 part 2-033/ EN 61010-2-033
DIN VDE 0411 part 031/ EN 61010-031
and has left the factory in perfectly safe technical condition.
To maintain this condition and ensure safe operation of the multimeter, the user
must observe the notes and warnings given in these instructions at all times.
The unit may be used only in power circuits within the over­
voltage category II with a conductor for 600 V max. to earth,
or within overvoltage category III with a conductor for 300 V
against ground.
Only use suitable measuring leads for this. With measurements
within measurement category III, the projecting conductive
part of a contact tip of the measuring leads must not be longer

than 4 mm.
Prior to carrying out measurements within measurement cat­
egory III, the push­on caps provided with the set and marked
with CAT III and CAT IV must be pushed onto the contact tips.
The purpose of this measure is user protection.
Remember that work on electrical components of all kinds is
dangerous. Even low voltages of 30 V AC and 60 V DC may be
dangerous to human life.

Before starting the multimeter up, always check it as well as all
cables and wires for signs of damage.
Should it appear that safe operation of the multimeter is no longer possible, it
should be shut down immediately and secured to prevent it being switched on
accidentally.
It may be assumed that safe operation is no longer possible:
- if the instrument or the measuring leads show visible signs of damage, or
- if the multimeter no longer functions, or
- after long periods of storage under unfavourable conditions, or
- after being subjected to rough transport.
In order to avoid danger,

­ do not touch the bare prod tips of the measuring leads,
­ insert the measurement leads in the appropriately desig­
nated measuring sockets on the multimeter
3.

Scope of delivery

The following items make up the standard BENNING CM 2 package:
3.1 One digital multimeter
3.2 One safety measuring leads (black)(L = 1.4 m)
3.3 One safety measuring leads (red)(L = 1.4 m)
3.4 One compact protection case
3.5 Two 1.5 V micro-batteries (installed in the multimeter when supplied)
3.6 One Operating Manual
Note on consumable parts:
- The BENNING CM 2 is supplied by two 1.5 V micro-batteries (2 x 1.5 V IEC
LR 03)
- The above mentioned safety leads (tested spare part) are approved in
accordance with CAT III 1000 V and for a current up 10 A.
4. Description of tester unit
The BENNING CM 2 is a digital current clamp multimeter with a measuring head
fitted with a Hall sensor.
See fig. 1:
The display and operating elements shown in fig. 1 are as follows:
 Housing
 Sliding switch for selecting the required functions.
- OFF
AC­voltage measurement (AC) and DC­voltage measurement (DC)
-
These functions alternate when the function button marked with AC/DC is
pressed. The digital display  indicates the current function.
AC­current measurement (AC) and DC­current measurement (DC)
-
These functions alternate when the function button marked with AC/DC is
05/ 2015
Front panel
BENNING CM 2

10