Publicidad
Idiomas disponibles
Idiomas disponibles
12. Connect the Components
NOTE: Make drip loops in all cables.
NOTE: If not already installed, install the digital valve, ON/OFF switch, and Perfect Fill System.
Route all component cables to the controller location. Refer to the "System Layout - Standalone Perfect Fill" section or
"System Layout - DTV+" section.
NOTE: Cables are labeled at the controller end. Verify that the cables are oriented correctly.
Gently press each connection into the proper port until each connection fully clicks in place.
Connect the power supply to the controller.
Plug the power cord into a 120 VAC GFCI electrical outlet.
1504928-2-A
Power Cord
Power Status LED
Error Status LED
Digital Mixing Valve
System Identification Button
Wireless Status LED
Not used
Pressure Sensor
Motor
DTV+ (Optional)
Not used
On/Off Switch
20
Kohler Co.
Publicidad
