Franke COUNTRY CL 85 M Manual De Instalación Y Servicio página 9

Models CL
(Fig. 6d)
Fit the appliance in the compartment;
fix the oven to the cabinet with the 4 screws
and the 4 bushings provided, using the holes
prepared in the side panels (Fig. 6d).
Models CM
(Fig. 6a/6b/6c)
X
Measure the width of the cabinet shoulder
(S), which normally can be 16, 18 or 20 mm.
16 mm shoulder: on each fixing bracket
–
(F) position 2 lugs (T) marked with
the number 16.
OPERATION
This oven combines the advantages of "static"
natural convection ovens with those of modern
"fan" ovens. It is a very versatile appliance
which enables safe and easy selection
of 8 different cooking methods. Use knobs
(A) and (D) on the control panel to select
the required programmes and temperature.
For best use of your Franke oven, consult
the cooking table on page 13.
Cooling fan
In order to reduce the temperature at the door,
control panel and sides, the Franke oven
is equipped with a cooling fan which
is automatically activated when the oven
is hot. When the fan is on, air blows from
the front of the oven between the front panel
and oven door; special attention has paid
to ensure that the exiting air does not disturb
the kitchen environment and that noise is kept
to a minimum.
To protect kitchen units, the fan keeps
running after cooking until the oven has
cooled down sufficiently.
CL 85 M / CM 85 M
18 mm shoulder: on each fixing bracket
–
(F) position 2 lugs (T) marked with
the number 18.
20 mm shoulder: the 20 mm shoulder
–
does not require the use of lugs.
X
Position the brackets (F) against the cabinet
shoulder and at the bottom on the oven
support top.
X
Secure the brackets (F) with the screws (V).
X
Position the oven inside the cabinet, open
the door fully and fix it to the brackets (F)
using the 4 screws (U) and the 4 plastic
spacers (D).
Note (applies to all models) (Fig. 6e)
If the oven is to be fitted under a cooktop,
firstly turn the top connection (R) to the right
or left so that the oven fits properly (Fig. 6e).
Oven light
This symbol corresponds to switching
on of the oven light without activation
of any type of heating. This option is useful
for cleaning the oven when it is switched off,
to see the cooking compartment.
Defrosting
To defrost the food, the following procedure
is recommended:
X
Set the programme selector knob (A) to the
position „TURBO GRILL".
X
Set the thermostat knob (D) to 0°C.
Electrical connection
Franke ovens are supplied with a three-pole
power cable with free terminals. If the oven
is permanently connected to the power supply,
install a device that ensures disconnection
from the power supply, with a contact opening
distance (at least 3 mm) enabling complete
disconnection in category III overvoltage
conditions. Make sure:
9 The plug and socket are suitable for a 16 A
current.
– 9 –
EN