Publicidad
Idiomas disponibles
Idiomas disponibles
5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Remove pin
and clip. Lower hanging ball and remove stop pin.
Then slide hanging ball off downrod.
[Refer to diagram 1.]
IMPORTANT: NEVER remove set screw from
hanging ball. The tiny hole on downrod is not for
the set screw. [Refer to diagram 1.]
Loosen yoke set screws and nuts at top of motor
housing. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod.
[Refer to diagram 2.]
Determine the length of downrod you wish to
use. Thread safety cable and electrical wires
through threaded end of downrod and pull extra
wire slack from the upper end of the downrod.
[Refer to diagram 2.]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--make sure wires do not get
twisted. Re-insert pin and clip that were
previously removed. Tighten yoke set screws and
nuts securely. [Refer to diagram 2.]
Remove canopy cover from underside of canopy
by turning canopy cover counterclockwise. Slide
yoke cover, canopy cover and canopy over
downrod. [Refer to diagram 3.] (Note: Canopy
cover must be turned with shiny side toward the
motor housing.)
Thread safety cable and wires through hanging
ball; then slide hanging ball over downrod.
Re-insert stop pin into top of downrod and raise
hanging ball. Be sure stop pin aligns with slots on
the inside of the hanging ball. Tighten set screw
securely. [Refer to diagram 4.]
WARNING: Failure to tighten set screw (on
hanging ball) completely could result in the
fan becoming loose and possibly falling.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
diagram 1
electrical wiring
downrod
diagram 2
electrical wiring
canopy
yoke cover
diagram 3
stop pin
diagram 4
page 5
hanging ball
clip
safety cable
yoke set screw
and nut
clip
safety cable
downrod
set screw
hanging ball
stop pin
pin
pin
motor
housing
canopy cover
motor
housing
Publicidad
