Craftmade KNE48 Guia De Instalacion página 9

9. Light Kit Assembly (Optional).
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted
holes in fitter plate with loosened screws in
motor plate, allowing molex connections
from motor housing to come through holes
in middle of fitter plate. Twist fitter plate to
lock. Re-insert screw that was just removed
and securely tighten all 3 screws with a
Phillips screwdriver.
Remove 1 screw from underside of fitter
plate and partially loosen the other 2
screws.
Connect WHITE wire from LED light kit to
WHITE wire from motor housing. Connect
BLUE (or BLACK) wire from LED light kit to
BLUE wire from motor housing. Be sure that
molex connections snap together
completely.
Carefully arrange wiring within fitter plate.
Align slotted holes in LED light kit with
loosened screws in fitter plate. Twist LED
light kit to lock. Re-insert screw that was
previously removed and tighten all 3 screws
securely.
Locate slots on shade and align with
nodules on inside of fitter plate.
push up on shade and turn
(clockwise) until it slides completely into
place.
If you do NOT wish to use the light kit,
locate slots on metal cover and align with
nodules on inside of fitter plate. Gently
push up on metal cover and turn to the
RIGHT (clockwise) until it slides completely
into place.
WARNING: Metal cover will be HOT if light
is left on.
Gently
to the RIGHT
page 9
motor housing
motor plate
fitter plate
molex
connections
motor housing
nodules
motor housing
nodules
LED light kit
fitter plate
slots
shade
fitter plate
slots
metal cover