Publicidad
Idiomas disponibles
Idiomas disponibles
11. Automated Learning Process./Activating Code.
CAUTION: The wall or handheld remote control can be programmed to multiple receivers or fans. If this is not
desired, turn wall switch off to any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on wall control to the ON position.
Within 60 seconds of turning on the wall control, press and hold the fan OFF button on the wall control for
5 seconds or until light blinks twice.
Turn power off again for at least 5 seconds and then turn power back on. Within 60 seconds of restoring
the power, press and hold the fan OFF button on the front of the handheld remote control for 5 seconds or
until light blinks twice.
Test the light and fan functions to confirm the learning process is complete--see Section 13 .
12. Remote/Wall Control Operation.
ON/OFF slider switch - turns wall control ON or OFF
HIGH button
MED button
LOW button
OFF button
L button
(switch not functional on handheld remote)
- turns fan to HIGH speed
- turns fan to MEDIUM speed
- turns fan to LOW speed
- turns fan OFF
- turns light kit ON/OFF when pressed once;
dims light kit when pressed and held
down.
wall control
page 11
handheld
remote control
Publicidad
