Descargar Imprimir esta página

Impecca ITAC-08KS21 Manual Del Usuario página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

n° 2: FeDDeRs 19 ¾ " Deep WAll sleeves
Wall Sleeve Brands:
4
3
4
5
4
8
8
3
4
#2 Fedders
1 . Remove existing rear grille as shown on page 9 of this
Remove existing rear grille as shown on Page
1.
manual and replace with provided louvered rear panel .
11 of this manual and replace with provided
louvered rear panel. Install as shown here.
Install as shown here .
NOTE: You may need to drill holes in flange
of existing sleeve to match new rear grille.
/
/
/
2. Attach(2)4 x3 x1
1
1
2
2
2
one on each side wall. Place in center of side
wall with the tapered end facing the opening.
3. Cut (2) 17 Tapered Spacer Blocks as shown
below into two pieces.
3
/
Tapered Spacer Block
4
Cut Here
4. The 4 section is placed in front of the rib on
base with the tapered end facing the back of
the sleeve. The remaining portion will be
placed behind the rib again sloping toward
the rear of the sleeve. This helps induce a
rearward slope on the unit.
5. Attach (1)1
x3/8 x25 long seal in the center
at the top of the sleeve. Remove the backing
paper and press into position.
6. Attach (2) 1
x3/8 x14 seals to the left and
right sides of the sleeve.
7. Cut (2) 1
x3/8 x25 long seals to 14 long
and attach it to the vertical sections of the rear
grille as shown.
8. Gently slide unit into sleeve.
9. Before sliding all-the-way back, remove 2nd
screw from front on left side of unit.
10. Remove the plastic washer from the screw.
11. Screw and attach the other end of the ground
wire to the unit as shown in picture. Make sure
that the toothed washer is against the cabinet.
12.Slide the unit completely to the rear to ensure
a good seal, making sure the ground wire does
not become tangled.
13.Seal & Frame the unit as described on page 22.
13 . Seal & frame the unit as described on p .20 .
14. If you have difficulty with mounting the grill to
14 . If you have difficulty with mounting the grill to the
the sleeve, follow the instructions for direct
sleeve, follow the instructions for direct mounting on p .19
mounting on Page 21.
13
11
19
3 4 /
Deep
/
/
centering/support blocks
1
2
2
17
1
4
Protection Paper
Backing

Publicidad

loading

Este manual también es adecuado para:

Itac-10ksa21Itac-12ksa21Itac-12ksb21