Publicidad
Idiomas disponibles
Idiomas disponibles
• Keep it out of direct sunlight.
• The remote control operates by means of an infrared beam.
• During use, there must not be any obstacle between the remote
control and the air-conditioner.
• If other appliances in the room have remote controls (TV, stereo,
etc...), there may be interference with consequent loss of the
sent signal.
• Electronic and fluorescent lights may also interfere with trans-
missions between remote control and air-conditioner.
• Remove the batteries in case of prolonged disuse of the remote
control.
• The remote control display goes off after a few seconds of non-
use, to reactivate it press any key.
3.3.1 - I nsertion of batteries (fig. 31)
To insert the batteries correctly:
a. Remove the batteries compartment
cover.
b. Insert the batteries into the relevant
compartment.
Check the polarity indicated on
the bottom of the compartment.
c. Close the compartment correctly.
3.3.2 - Replacement of batteries
The batteries should be replaced when
the display on the remote control does not
appear sharply or when the remote control
does not change the settings.
Always use new batteries and replace both at the same time.
The use of old or different batteries could generate malfunctioning
of the remote control.
The remote control uses two dry alkaline 1.5V batteries (AAA.LR03) (fig. 31).
When the batteries have been replaced, adjust the remote control clock.
31
T1
EN - 25
UNICO
Publicidad
