BIG ASS FANS COOL-SPACE 400 Manual De Operación Y Mantenimiento página 3

☑ Make sure the inside of the cooler is clean and that the water reservoir is free of dirt and debris.
☑ Place the cooler on level ground.
☑ Position the cooler so that obstacles such as racks and workbenches do not interfere with airflow.
☑ Provide uninterrupted fresh air intake and maintain a minimum clearance of 3 ft (0.9 m) behind the cooler.
☑ Provide adequate ventilation. Do not operate the cooler in an enclosed space.
☑ Make sure discharged cool air will be free of obstructions.
☑ Make sure the water supply pressure does not exceed 60 PSI (4 bar/414 kPa).
☑ Make sure the cooler will be plugged into a fused or breaker-protected circuit. Refer to the tables below for
electrical requirements.
☑ If using an extension cord, use a 12 gauge cord if the cord is shorter than 50 ft (15 m) or a 10 gauge cord if
the cord is longer than 50 ft (15 m). Refer to the tables below for details.
Electrical Requirements
Model
Cool-Space 400
®
Three-Conductor Heavy Duty Extension Cord Requirements (120 V)
Cord Length
0–50 ft (0–15 m)
50–100 ft (15–30 m)
Three-Conductor Heavy Duty Extension Cord Requirements (220/230 V)
Cord Length
6 m
16 m
32 m
This product contains an IP rating of IPX5: Protection against ingress of water.
BEFORE YOU START
Volts +/- 10%
100–120 V
200–240 V
16 GA
13 A
10 A
1.5 mm
2
13 A
13 A
10 A
WWW.BIGASSFANS.COM © 2023 DELTA T LLC
Frequency Min. Circuit Size
60 Hz
50/60 Hz
Cord Size
14 GA
18 A
13 A
Cord Size
2.5 mm
2
15 A
14 A
12 A
ALL RIGHTS RESERVED.
Running Amps
15 A
10 A
12 GA
25 A
18 A
4 mm
2
15 A
15 A
13 A
8.75 A
5.52 A
10 GA
30 A
25 A
5 mm
2
15 A
15 A
15 A
1