Invacare Matrx MX2 Back Manual Del Usuario página 7

3.2 MX2 BACK INSTALLATION & SET-UP
IMPORTANT! Installation and set-up of the Matrx MX2 Back MUST be
performed by a Qualified Service Technician and/or Healthcare Professional.
®
• The Invacare
are up to 1" (25mm) wider or 1" (25mm) narrower than than the nominal back width.
®
• The Invacare
Removable hardware (optional)
• Installation of the Invacare
with an outside diameter greater than 1" (25mm) or less than 3/4" (19mm).
3.3 MX2 LUMBAR SUPPORT (Optional)
The optional Lumbar Support is a pre-fabricated foam insert that provides lower
back support for additional comfort. The position of the lumbar insert can be adjusted
inside the Invacare
if no lumbar support is desired.
1. To access the lumbar support, open the hook and loop fastening strips on
the outer cover A at the bottom rear of the back shell.
2. The foam lumbar support B is installed inside the Invacare
cover between the foam back cushion C and the back shell D.
3. The lumbar support can be adjusted to any desired height/position.
4. Refasten the cover (via hook and loop strips) onto the back pan.
Lumbar Support
FRONT
®
Matrx MX2 Back has been designed to install onto back canes that
®
Matrx MX2 Back may be configured with Fixed Hardware or
®
Matrx
® ®
Matrx MX2 cover (see instructions below), or it may be removed
- 7 -
®
MX2 Back is limited to wheelchair back canes
*NOTE: The lumbar foam may
be cut/modified as needed, to
meet the needs of the end user.
adjust lumbar position as
needed or remove completely
® ®
Matrx MX2