Publicidad
English
The power is not on.
The power goes off.
The cassette cannot be
removed from the
holder.
No function except for
cassette ejection works.
The tape does not move
when a tape transport
button is pressed.
The battery pack is not
attached or not attached
firmly.
The battery is dead.
Attach the battery pack
firmly by pushing the lower -
part of the battery pack.
Use a charged battery pack.
The AC power adaptor is not
connected to a wall outlet.
Connect the AC power
adaptor to a wall outlet.
While being operated in
CAMERA mode, the
camcorder has been in the
Standby mode for more than
5 minutes.
Turn STANDBY down once
and turn it up again.
The battery is dead.
Use a charged battery pack.
The ambient temperature is
too low.
The battery pack has not been
charged fully.
The battery pack is
completely dead, and cannot
be recharged.
The tape is stuck to the drum.
The tape has run out.
The POWER switch is set to
PLAYER.
The tab on the cassette is out
(red).
The battery is dead.
Charge the battery pack
again.
Use another battery pack.
Eject the cassette.
Rewind the tape or use a
new one.
Set to CAMERA.
Use a new cassette or slide
the tab.
Use a charged battery pack
or the AC power adaptor.
Moisture condensation has
occurred.
Remove the cassette and
leave the camcorder for at
least an hour.
The POWER switch is set to
CAMERA or OFF.
Set it to PLAYER.
The tape has run out.
indicator disappears.
You pressed DATE and TIME
together for more than 2
seconds.
Rewind the tape or use a
new one.
The camcorder is not
malfunctioning. You may
start recording. Flashing will
stop soon.
Reset the date and time.
{to be continued)
uo}eW
|eUOPI
eUO!IP
UO!eWI
53
Publicidad
